HD Tune: WDC WD1600JB-00HUA0 Information

Firmware version : 15.05R15
Serial number : WD-WMAM51076555
Capacity : 149.0 GB (~160.0 GB)
Buffer size : 8192 KB
Standard : ATA/ATAPI-6
Supported mode : UDMA Mode 5 (Ultra ATA/100)
Current mode : UDMA Mode 5 (Ultra ATA/100)

S.M.A.R.T : yes
48-bit Address : yes
Read Look-Ahead : yes
Write Cache : yes
Host Protected Area : yes
Device Configuration Overlay : yes
Automatic Acoustic Management: yes
Power Management : yes
Advanced Power Management : no
Power-up in Standby : no
Security Mode : yes
Firmware Upgradable : yes

Partition : 1
Drive letter : C:\
Label :
Capacity : 29996 MB
Usage : 74.85%
Type : NTFS
Bootable : Yes

Partition : 2
Drive letter : D:\
Label :
Capacity : 122628 MB
Usage : 15.35%
Type : NTFS
Bootable : No

---------------------------------------------
HD Tune: WDC WD1600JB-00HUA0 Health

ID Current Worst ThresholdData Status
(01) Raw Read Error Rate 200 197 51 0 Ok
(03) Spin Up Time 124 107 21 4333 Ok
(04) Start/Stop Count 99 99 40 1608 Ok
(05) Reallocated Sector Count 199 199 140 1 Ok
(07) Seek Error Rate 200 200 51 0 Ok
(09) Power On Hours Count 92 92 0 6460 Ok
(0A) Spin Retry Count 100 100 51 0 Ok
(0B) Calibration Retry Count 100 100 51 0 Ok
(0C) Power Cycle Count 99 99 0 1407 Ok
(C2) Temperature 110 253 0 40 Ok
(C4) Reallocated Event Count 199 199 0 1 Ok
(C5) Current Pending Sector 200 200 0 5 Ok
(C6) Offline Uncorrectable 200 200 0 4 Ok
(C7) Ultra DMA CRC Error Count 200 253 0 0 Ok
(C8) Write Error Rate 200 155 51 0 Ok

Power On Time : 6460
Health Status : Ok
-------------------------------------------------------------------------------------------------

This is the info from HDTune. but, my problem is not with my hard drive, i
have a second partition on that same one, and CHKDSK runs fine on it. But it
won't run during boot on my Windows partition (C. it's scheduled to run,
however it won't ever run! is there a way i can disable this schedule? i have
other disk management utilities that can't run because CHKDSK is scheduled to
run.