I am trying to do a new installation on a new harddrive. Unfortunately
the computer usually shuts off before the install gets going. When the
windows cd has been able to begin formatting, it only got to 20% and
stalled. The next day I finally shut it off.

The hard drive is 160GB and of course windows only recognizes 137 GB.

Any help would be much appreciated.

adullam04-excelgoogle@yahoo.com wrote:

> I am trying to do a new installation on a new harddrive.
> Unfortunately
> the computer usually shuts off before the install gets going. When
> the windows cd has been able to begin formatting, it only got to 20%
> and
> stalled. The next day I finally shut it off.
>
> The hard drive is 160GB and of course windows only recognizes 137 GB.
>
> Any help would be much appreciated.

If the computer shuts off before you can even get going with an
operating system installation, you have hardware problems. I'm assuming
you are doing a clean install. If not, post back with a better
description of exactly how you are installing and some information
about your computer.

Here are some general hardware troubleshooting steps:

1) Open the computer and run it open, cleaning out all dust bunnies and
observing all fans (overheating will cause system freezing). Obviously
you can't do this with a laptop, but you can hear if the fan is running
and feel if the laptop is getting too hot.

2) Test the RAM - I like Memtest86+ from www.memtest.org. Obviously, you
have to get the program from a working machine. You will either
download the precompiled Windows binary to make a bootable floppy or
the .iso to make a bootable cd. If you want to use the latter, you'll
need to have third-party burning software on the machine where you
download the file - XP's built-in burning capability won't do the job.
In either case, boot with the media you made. The test will run
immediately. Let the test run for an hour or two - unless errors are
seen immediately. If you get any errors, replace the RAM.

3) Test the hard drive with a diagnostic utility from the mftr. Download
the file and make a bootable floppy or cd with it. Boot with the media
and do a thorough test. If the drive has physical errors, replace it.

4) The power supply may be going bad or be inadequate for the devices
you have in the system. The adequacy issue doesn't really apply to a
laptop, although of course the power supply can be faulty.

5) Test the motherboard with something like TuffTest from
www.tufftest.com. Sometimes this is useful, and sometimes it isn't.

Testing hardware failures often involves swapping out suspected parts
with known-good parts. If you can't do the testing yourself and/or are
uncomfortable opening your computer, take the machine to a professional
computer repair shop (not your local equivalent of BigStoreUSA).

Malke
--
Elephant Boy Computers
www.elephantboycomputers.com
"Don't Panic!"
MS-MVP Windows - Shell/User