USB flash drive

I have a 128mb keychain flash drive that connects to the USB port. It
works fine in WinXP, but I would like to access it under DOS.

I have tried using a DOS 7 floppy boot disk with the recommended diver
(USBASPI.SYS) with no sucess. On bootup, there is a message displayed
to connect the USB device and press enter, but it fails to detect the
drive. The config.sys file reads

DEVICE = USBASPI.SYS /w /v

Any ideas?

-Bill

not supported, buy a case of floppies


<wrongaddress@att.net> wrote in message
news:1135995433.125452.277000@g43g2000cwa.googlegr oups.com...
|I have a 128mb keychain flash drive that connects to the
USB port. It
| works fine in WinXP, but I would like to access it under
DOS.
|
| I have tried using a DOS 7 floppy boot disk with the
recommended diver
| (USBASPI.SYS) with no sucess. On bootup, there is a
message displayed
| to connect the USB device and press enter, but it fails to
detect the
| drive. The config.sys file reads
|
| DEVICE = USBASPI.SYS /w /v
|
| Any ideas?
|
| -Bill
|

"Jim Macklin" <p51mustang[threeX12]@xxxhotmail.calm> wrote in message
news:%23NmsEUuDGHA.4064@TK2MSFTNGP10.phx.gbl...
> not supported, buy a case of floppies
>
>
> <wrongaddress@att.net> wrote in message
> news:1135995433.125452.277000@g43g2000cwa.googlegr oups.com...
> |I have a 128mb keychain flash drive that connects to the
> USB port. It
> | works fine in WinXP, but I would like to access it under
> DOS.
> |
> | I have tried using a DOS 7 floppy boot disk with the
> recommended diver
> | (USBASPI.SYS) with no sucess. On bootup, there is a
> message displayed
> | to connect the USB device and press enter, but it fails to
> detect the
> | drive. The config.sys file reads
> |
> | DEVICE = USBASPI.SYS /w /v
> |
> | Any ideas?
> |
> | -Bill
> |
>
>

Actually, one way that might work is if the machine can boot from the USB
drive (it must be fairly modern). Then the USB drive will be accessible (as
c even from DOS without any drivers. I have done this on several machines
built in the last 3 years. Unfortunately, the machines (Dells) do not make
the USB drive accessible if it is not the boot drive.

I also tried some of those DOS drivers and never had any luck with them.

Peter

wrongaddress@att.net wrote:

> I have a 128mb keychain flash drive that connects to the USB port. It
> works fine in WinXP, but I would like to access it under DOS.
>
> I have tried using a DOS 7 floppy boot disk with the recommended diver
> (USBASPI.SYS) with no sucess. On bootup, there is a message displayed
> to connect the USB device and press enter, but it fails to detect the
> drive. The config.sys file reads
>
> DEVICE = USBASPI.SYS /w /v
>
> Any ideas?
>
> -Bill
>

For DOS, the device needs to be included as part of the
boot up...no hot-swapping.

> For DOS, the device needs to be included as part of the
> boot up...no hot-swapping.

Thanks, do you have an example to setup a boot disk?
What drivers to use and what switches to set, etc. ?

-Bill